This set is designed to withstand the demands of a busy salon. Follow these steps for proper setup and long-lasting performance:

1. Installation: Screw the end of the shower hose onto the backwash faucet connector. Make sure the rubber seal is in place and avoid over-tightening to prevent damage to the threads.

2. Temperature Check: Always test the water temperature on your own wrist before directing the stream onto the client's hair.

3. Water Pressure: The shower head provides an optimized spray. Adjust the pressure gently at the faucet to avoid splashing outside the basin.

4. Maintenance: Wipe the shower head dry at the end of the day to prevent limescale buildup. If you have hard water, soak the head in a mixture of water and vinegar once a month to maintain a perfect flow.

This set is designed to make home hair washing simple and comfortable. You can set it up in just a few moments:

1. Setup: Screw the end of the shower hose onto your faucet connector. Make sure the small rubber washer (seal) is inside the connector to prevent leaks. Tighten it by hand only, no tools needed!

2. Usage: The 110 cm hose gives you plenty of room to move, but try not to pull it too hard at the ends. The shower head is ergonomically shaped to fit perfectly in your hand during washing.

3. Check the Heat: Always test the water temperature on your wrist before directing the spray onto the scalp to avoid any accidental burns.

4. Cleaning: If the water starts flowing unevenly, it’s likely due to limescale buildup. Simply soak the shower head in a mixture of water and vinegar for a while, and it will work like new again.

Manufacturer and distributor:
Alveola Ltd.
Hungary, 1143 Budapest Gizella street 28/a
Tel: +36 1251 2270
information [at]alveola.com